Block Volcano Hideout Decor

⚙️ Recommended Print Settings

This structural print is designed for a specific vertical orientation for the best surface texture and layer adhesion. No sealing or hollowing is required.

FDM/Filament Settings (Recommended for Structure & Size)

• Material: PETG or ABS/ASA is recommended for high-humidity vivarium environments.

• Layer Height: 0.2 mm.

• Infill Density: 10-15%.

• Wall/Perimeter Count: 3.

• Orientation (CRITICAL): Print the model flat on its base for maximum stability. Minimal supports may be required beneath small overhangs, depending on your cooling performance.

SLA/Resin Settings (Recommended for Detail)

• Material: Standard UV Resin (Grey or Sandstone color).

• Layer Height: 0.05 mm or finer.

• Orientation (CRITICAL): Print flat on its base. Minimal support may be required depending on the specific model orientation and any fine details.

• Preparation: No hollowing or drainage holes needed.

Important: Always thoroughly clean your final print before placing it in a viarium. Avoid using metal-filled or abrasive filaments. For long-term use, ensure your chosen material is chemically stable in water.