Aquarium Fish Portal Set

⚙️ Recommended Print Settings

Successfully printing this aquatic accessory is straightforward. We highly recommend using a water-resistant filament for long-term safety and durability in your aquarium.

Filament & Material

• Recommendation: PETG, ABS, or ASA.

• Notes: PETG, ABS, or ASA is highly recommended for longevity in water due to moisture resistance. Standard PLA can be used, but may degrade over time or may require a food-safe resin coating for long-term submersion.

Layer Height

• Recommendation: 0.2 mm.

• Notes: A standard layer height for a great balance of detail, strength, and print time.

Slicer Settings

• Infill Density: 0%. This print does not require infill.

• Top Shell Layers: 0. Very important, as this will make the floaters hollow with an open bottom.

• Wall/Perimeter Count: 2-3. Use a higher count (3) to ensure the floating ring is completely sealed, waterproof, and more robust.

• Nozzle Temperature: Material Specific. Follow your filament manufacturer’s guidance (e.g., PETG: 235-250°C / PLA: 200-220°C).

Adhesion & Supports

• Supports: None. Designed to print without supports on a standard FDM printer. Print the model flat on the build plate.

• Brim/Raft: None. A small 5mm brim may be beneficial only if you experience bed adhesion issues, particularly with PETG.

Slicing Note

• Scaleable: The files are pre-sized for optimal use. Scale them to your desired need.

Important: Always thoroughly clean your final print before placing it in an aquarium. Avoid using metal-filled or abrasive filaments. For long-term use, ensure your chosen material is chemically stable in water.